Large Format Auto Open Heat Press with Slide-out Press Bed Manual
- 4-
When SV and PV has a big difference,
press
button for 5 seconds, and press
button again to adjust the temperature.
If SV&PV has difference of 20 degrees,
Press arrows “
△
” or “
▽
” to set to 20.
When the temperature shows on the
display is not the same as actual
temperature on heat platen, press
button for 5 seconds to reset mode:
When display shows 200°C,the actual
heat platen temperature is 170 °C, Press
arrows “
△
” or “
▽
” to set to 30.
When display shows 200°C,the actual
heat platen temperature is 230 °C, Press
arrows “
△
” or “
▽
” to set to -30
2. Printing method
Step 1: Make sure the cord is connected well to the wall socket.
Lift up on the handle to open the press. The press
should always be in the open position when the press is heating.
then draw out the under plate and place
the object (i.e. T-shirt , banner etc) and transfer paper with images facing down the object on under plate;
adjust the pressure to be moderate and switch on the press.
Step 2: Set the temperature and time required, then temperature starts to rise.
Step 3: When the temperature rises to the set temperature, the buzzer sends out sounds; then close down the
handle of heat platen. Time counter is on, and electromagnet starts working (meantime the sounds stop).
The handle should lock firmly in place and should point straight-forward.
Step 4: Time is counting down; once time is up, the heat platen will open automatically.
Step 5: Consult the Transfer Paper instructions on whether to peel cold or hot, Here are suggested pressing time
guidelines for different transfer paper.
Ink-Jet Transfer Paper (fabric) 14-18 seconds
Laser Copier/Printer Transfer Paper (fabric) 18-25 seconds
Sublimation Transfers (onto Fabrics) 25-30 seconds
Sublimation Transfers (onto FR-Plastic/Woods) 60-70 seconds
STEP 6: Mouse pads, coasters, and other thicker materials may also be pressed. Simply adjust the pressure
adjustment knob -
clockwise to increase pressure, and counterclockwise to decrease pressure
.
3. Recommendations:
1) Ceramic tile transfer: (Mugs & Plates transfer is similar)
Set temperature: 180
℃
.
Set time: 15 seconds
2) T-shirt transfer:
MICROTEC
