microSYST MS8111PWM3S, Руководство пользователя

Страница: 16 / 17

SrEG
0 - K3 - ALARM
К3 – TIMER –
timer operates independently of the measured input variables
129 –
mode 1 in seconds
130 –
mode 1 in minutes
131 –
mode 2 in seconds
132 –
mode 2 in minutes
133 -
mode 1 in seconds x 0.1
134 -
mode 2 in seconds x 0.1
•
The modes in seconds are indicated with a decimal point
K3 – TIMER- is started
depending of the measured input
variables
1 – mode 1 in seconds
2 – mode 1 in minutes
3 – mode 2 in seconds
4 – mode 2 in minutes
5 – mode 1 in seconds x 0.1
6 – mode 2 in seconds x 0.1
The modes in seconds are
indicated with a decimal point
To start when the set point is reached,
add to the value of parameter :
32 – start at PV1>SP1 & PV2>SP2
40 – start at PV1<SP1 & PV2>SP2
48 – start at PV1>SP1 & PV2<SP2
56 – start at PV1<SP1 & PV2<SP2
64 – start at PV1>SP1 or PV2>SP2
72 – start at PV1<SP1 or PV2>SP2
80 – start at PV1>SP1 or PV2<SP2
88 – start at PV1<SP1 or PV2<SP2
96 – start at PV1>SP1
104 – start at PV1<SP1
dPnt
Decimal points of the channels
(MEANINGFUL, ONLY IF IT’S
SCALING!)
ONLY FOR SERVICE
SPECIALISTS
0 ... 255
X . X . X . X .
X . X . X . X .
PA 1 Division coefficient of analog output1*
-1999 ... 9999
PA 0 Offset of analog output 1*
PB 1 Division coefficient of analog output2*
PB 0 Offset of analog output 2*
rs__
Initialize communication through serial
channel
Do not press SET
* The calculation of the analog output is done by the following formula :
0
1
1023 *
PX
PX
PV
Aout
 
, where PV is the value of the measured parameter, and PX1 and PX0
are PA1 and PA0 or PB1 and PB0 respectively.
Редакция документ 2018-11-02
16
32
64
128 16
1
2
4 8