miriac SBC-S32G-R3_User Manual
V 3.2
9/65
© MicroSys Electronics GmbH 2021
3
Quick Start Guide
3.1
Prerequisites
Always take the necessary ESD precautions when handling the
SBC-S32G274A. Otherwise, the unit may suffer permanent
damage.
Do not place the unit directly flat on a metal surface, as this
may result in short circuits and damage to the board.
Before first using the SBC, unpack the unit and make sure that is clean and free of
visible damage or foreign objects.
3.1.1 Minimum Requirements
To operate the board, you will at least need the following items:
■
an adequate power supply, delivering 12V DC (stabilized) / 2A minimum.
■
a USB cable (type A
– mini B) connected to ST6.
■
a serial terminal, such as a PC with a USB port running a terminal software
(e.g. TeraTerm, HyperTerminal, minicom, putty, ckermit...), or else a hardware
serial console.
Choose the following parameters:
(a)
115200 Bd
(b)
8 Data bits
(c)
No parity
(d)
1 Stop Bit
3.1.2 Recommended Items
The following items are not absolutely necessary, but strongly recommended for
practical operation and development purposes:
■
Network connection to your local network installation
■
TFTP server available for downloading within the network (may run on the
same PC as the serial terminal)
■
SD card as mass storage and/or boot media
