3. Install the first of the bearings into the
In-Line Skate Speedometer Wheel.
Push
one bearing with your fingers into the hole
of the Skate Speedometer Wheel (Picture 5).
4. Place the correct spacer into the In-Line
Skate Speedometer Wheel.
Decide which
of the In-Line Skate Speedometer Spacers
you need. Principally if your original spacer
looks cylindrical you need the cylindrical
spacer. If your original spacer is a 1 cm thick
ring you need the 3 mm ring spacer. Now
place the spacer into the In-Line Skate
Speedometer Wheel (Pictures 6+7).
Picture 5
Picture 6
Picture 7
Microsport_Basic_11/02 11.11.2002 15:16 Uhr Seite 53
