Installation-Switch 45x45 with TP-Uplink
Page
5/6
MICROSENS
GmbH & Co. KG - Kueferstraße 16 - D-59067 Hamm / Germany - Tel. +49 23 81/94 52-0 - FAX -100 - www.microsens.com
Resetting of the Switch
It is possible to reset the Switch by using the two buttons, which are integrated in the RJ45
sockets of the ports 1 and 2.
The buttons have following functions:
Reset Factory Default
Reset / IP Confuguration
Fig.. 3: Position of the reset buttons
1. Reset / IP-Configuration
Reset:
The switch can be reset by short pressing of the relevant button. Then the last stored
configuration is loaded into the unit. The Management configuration such as IP address and unit
name is not changed.
Attention: During the reset the data transmission via the switch is interrupted
IP-Configuration:
Longer pressing (approx. 5 sec) of the relevant button causes the IP Configuration after the
done reset. Now the IP address and the unit name can be given in via a network computer with
started Device Manager Software.
2. Factory Reset
By continuously pressing of the relevant factory reset button while activity of the reset button
(port 1) all in the unit stored configuration settings are reset to factory adjustments. The
configuration of the agent like IP address and unit name will not be changed.
The “factory reset” is only relevant for the switch data, not for the integrated management
agent. Only port configurations, priorities and VLAN settings will be reset.
