Microsemi ZLE30267, Руководство по оборудованию

Страница: 13 / 30

ZLE30267 Hardware Guide
December 2015 13
Board
Config.
Number Serial
Bus
Master
Serial
Bus Slave
Description Switch and Jumper Settings
USB Controller IO
Pin Settings
3 USB
(SPI) JP1 or
JP5 GUI/PC controls external
EEPROM connected at header,
or external DUT via SPI cable,
and serial bus configuration.
If DUT is running, GPIO DIPs
should be left as configured.
JP9 = on
JP6: all open
SW1.IF0 = 1
SW1.IF1 = 1
SW1.PUPD_ENB = 0
FT_FSW_OEB = 0
FT_HW_SEL = 0
FT_SPI_SEL = 1
FT_DSW_SEL = x
FT_ESW_SEL = 0
FT_ESW_OEB = 0
FT_PUPD_ENB = hi-Z
FT_AC0_GPIO0 = hi-Z
FT_AC1_GPIO1 = hi-Z
FT_AC2_GPIO2 = hi-Z
FT_TEST_GPIO3 = hi-Z
FT_GPIO3 = hi-Z
4 DUT
(SPI) EEPROM ZL30260/2/4/6 and ZL40250/2
DUT loads from on-board
EEPROM (standalone board
operation).
ZL30261/3/5/7 and ZL40251/3
DUT will not load from external
EEPROM device.
JP9 = open
JP6: shunt pins 1-2, 3-4, 5-6, 7-8
SW1.IF0 = 1
SW1.IF1 = 1
SW1.TEST_GPIO3 = 0
SW1.PUPD_ENB = 0
SW2.DSW_SEL = 1
SW2. ESW_OEB = 0
SW2. ESW_SEL = 1
[SW1.AC2_GPIO2,
SW1.AC1_GPIO1,
SW1.AC0_GPIO0] = select
EEPROM configuration # 0 to 7
N/A
5 DUT
(SPI) JP1 or
JP5
Header ZL30260/2/4/6 and ZL40250/2
DUT loads from external
EEPROM connected to header.
ZL30261/3/5/7 and ZL40251/3
DUT will not load from external
EEPROM device.
JP9 = open
JP6: open
SW1.IF0 = 1
SW1.IF1 = 1
SW1.TEST_GPIO3 = 0
SW1.PUPD_ENB = 0
SW2.DSW_SEL = 1
SW2. ESW_OEB = 0
SW2.ESW_SEL = 1
SW1.AC2_GPIO2,
SW1.AC1_GPIO1,
SW1.AC0_GPIO0 = select
EEPROM configuration # 0 to 7
N/A