ZL70550 Application Development Kit (ADK) User’s Guide
Revisio n 1
8
driver manually. At that point, take the steps necessary to install the driver located in
one of the following folders:
−
For Windows 8 and later, use
C:\Program Files (x86)\Microsemi\ZL70550 ADK
\USB Driver\Signed (for Windows 8 and newer)
−
For Windows 7 and earlier, use
C:\Program Files (x86)\Microsemi\ZL70550 ADK
\USB Driver\Unsigned (for Windows 7 and older)
If you need guidance, the driver folders contain files with example instructions for
installing FTDI USB drivers on various Windows platforms. For example, if the PC is
running Windows 10, see the file
FTDI Drivers Installation Guide for Windows 10.pdf
.
In the example instructions, follow the steps to manually search for and install the
driver, substituting
Application Unit
for the device named in the example, and
substituting the driver folder shown above for the driver folder shown in the example.
Ignore any instructions to download and install files from FTDI’s website, because the
driver folder shown above contains all of the needed files. Also, ignore any
instructions to install the
Virtual COM Port
driver because it is not used.
5. Using the second supplied USB cable, connect the remote unit to a PC via the mini-B
connector located on the ADP200 board. For Windows 7 and later, Windows should
automatically use the same driver that was installed in the previous step. If it does not
do so, repeat the instructions from the previous step to install the device driver for the
remote unit.
6. Power on the base unit. Note that the power switch is located on the ADP200 (refer
on page
). Sliding this switch up (away
from the mini-B USB connector) turns on power to the whole unit.
7. Power on the remote unit (refer to the note in the previous step).
