Microsemi DVP-102-000512-001, Демонстрационное руководство

Страница: 9 / 17

PolarFire Dual Camera Video Kit
Microsemi Proprietary DG0849 Demo Guide Revision 1.0 4
2.4 Installing the Demo GUI
To install the GUI:
1. Extract the
Installer.rar
file from the
<$DownloadedFolder>\Installer
folder and run the
setup.exe
file.
2. Click Yes for any message from User Account Control.
The
Video Control GUI installation wizard is displayed.
3. Confirm the installation directory locations for the GUI and the National Instruments products and
click
Next .
4. Accept the license agreement, and click Next .
5. Review the summary and click Next .
The installation proceeds with a progress bar. After the installation, a confirmation message is dis-
played.
6. Click Next to exit the installation wizard.
7. Restart the host PC when prompted.
The Video_Control GUI is installed.
2.5 Setting Up the Demo
Setting up the demo involves the following steps:
1. Setting Up the Hardware, page 4
2. Programming the PolarFire Device, page 5
2.5.1 Setting Up the Hardware
Setting up the hardware involves interfacing the dual camera sensor module with the PolarFire Video Kit
and verifying the jumper settings. The following steps describe how to connect the camera module to
video kit.
1. Connect the J1 connector of the dual camera sensor module to J38 interface of the video kit.
2. Connect the video kit and the HDMI monitor through J2 (HDMI 1.4) of the video kit using the HDMI
cable.
3. Connect the Host PC and the video kit through J12 of the video kit using the USB mini cable.
4. Connect the power supply cable to J20 of the video kit.
5. Ensure that the following jumper settings are set on the video kit.
6. Power-up the HDMI monitor.
7. Power-up the board using the SW4 slide switch.
Table 2 • Jumper Settings
Jumper Default Position Functionality
J15 Open SPI Slave and Master mode selection. By Default SPI
master
J17 Open 100K PD for TRSTn, by default 1K PD is connected.
J19 Pin 1&2 Default: XCVR_VREF is connected to GND
J28 Pin 1&2 Default: Programming through the FTDI
J24 Pin 2&4 Default: VDDAUX4 voltage is set to 3V3
J25 Pin 5&6 Default: Bank4 voltage is set to 1V8
J36 Pin 1&2 Default: Board power up through the SW4
SW4 OFF (Pin 2-3,5-6 Positions) Power ON\OFF switch
SW6 OFF position user slide switch, Default OFF position
J20 12Volts Input 12V input to the board