MicroPower SMC-HF 10000, Руководство пользователя

Страница: 13 / 176

English
WARNING
The charging process must be switched off when disconnecting the battery. If the
battery is disconnected while the charging process is in progress, the contacts in
the charging connector will be damaged and sparks may be generated that could
cause a hydrogen explosion.
SMC-HF 3200
6HWWKH6WDUW6WRSEXWWRQRQWKHSDQHOWRSRVLWLRQ
SMC-HF 8000
/10000
Maintenance
Troubleshooting
Safety shut-off
Charging is interrupted if:
‡
‡
‡
‡
Charging will be temporarily interrupted or reduced if:
Check of error messages
SMC-HF 3200
/('V$UHGÀDVKLQJ/('LQGLFDWHVDFKDUJLQJIDXOW$SHUPDQHQWUHGOLJKWLQGLFDWHVD
SMC-HF 8000
/10000
6. Switching off the battery charger.
7. The STANDBY LED comes on, showing a green light.
8. Disconnect the battery from the battery charger.
1. Pause the charging process by pressing the pause button II
2. Disconnect the battery immediately after the battery charger’s pause button has
been pressed. Charging will recommence after 10 seconds if the battery is still con-
nected.
May only be carried out by authorised personnel.
Periodically, depending on location, the equipment should be checked and cleaned of
dust etc.
May only be carried out by authorised personnel.
The recharged number of ampere-hours exceeds the estimated value.
The charging time for any of the charging phases exceeds the calculated value.
The voltage and current exceed the approved average value.
The battery has been disconnected without the charger being switched off.
The temperature exceeds the permitted values.
When the battery charger’s built-in self-test detects a fault, this is indicated by the
fault in the charger.
See the ”Symbol indication in SMC-HF 8000/10000” section.
Note any faults and contact authorised service personnel.
13