MicroPower SLV-C306-1011-IR, Руководство по установке, Страница: 21 / 40

21
Camera Kit Assembly & Installation
Next we will cover how the cameras and camera components are assembled and installed. Some installers find it
easier to do the assembly process on multiple cameras at the same time, and bring the cameras to the pole “ready
to bolt on”. Others prefer to assemble the parts at each location. Regardless the camera / solar panel / antenna
assembly process should be done on the ground, prior to actually mounting any of the equipment. As much as
possible this guide is moving in chronological order, so we will first cover the assembly of the parts, and then
address the mounting / installation process.
System Assembly
Camera Assembly
The camera itself only needs to have the camera swivel
bracket attached to it.
1. Remove the camera bracket from the packaging, and
remove the pivoting mount from the main bracket,
by removing the single screw that holds it in place.
Replace the screw back into the pivoting bracket to
prevent it from being lost.
2. Place the rubber bracket pad on the camera housing,
and line up the captive screws with the holes.
3. Next, mount the bracket hinge on the underside of
the camera by using the small/shallow Phillips screws
included in a small plastic bag that may be found in
the packaging.
4. Before tightening the bracket to the camera housing,
slide it up and down the housing until you can lift the
camera by the bracket, and find that it is balanced. A
balanced camera will make the later mounting process
much easier.
5. If your camera is equipped with an IR illuminator, you
can plug it into one of the two power sockets at this
time. The other power socket will be used by the solar
panel input.
Antenna
Connection
Solar Panel
Connection
IR Illuminator or
Supplamental
Solar Panel
Connection