1
Safety Instructions
For the correct and effective use of this equipment, to maintain safety and avoid hazards
it is essential that you read and understand these instructions fully and act accordingly
BEFORE operating this equipment.
1.1
Warnings
•
This equipment is certified and intended for use in potentially hazardous areas.
•
For installations in North America the National Electrical Code (NEC) should be strictly
observed.
•
Where appropriate local or national regulations should be used.
•
The enclosure lid and body should always be fully tightened and locked into position before
energising the equipment.
•
Do not open the enclosure in the presence of a flammable atmosphere.
•
All permits and proper site procedures and practices must be followed.
•
Repair of equipment should never be performed by non-trained personnel.
1.2
Cautions
•
Use only approved parts and accessories with this equipment.
•
Do not attempt to replace the window as the glass and the front cover are
individually matched pairs to meet the stringent requirement of the Hazardous area
certification.
•
The threaded portions of the detector are flame paths. These threads and the flame
paths around the window are not to be repaired.
•
To maintain safety standards, regular maintenance should be performed by qualified
personnel.
1.3
Important Notices
•
Pay attention to the guidelines given throughout this document.
•
If in any doubt ask your local sales representative or contact Micropack (Engineering) Ltd.
•
Micropack (Engineering) Ltd takes no responsibility for use of its equipment if this is not in
accordance with the appropriate issue and/or amendment of the manual.
•
Micropack (Engineering) Ltd reserve the right to change or revise the information contained
herein without notice and without obligation to notify any person or organisation of such
action.
micropack.co.uk
PAY PARTICULAR ATTENTION TO ALL SAFETY WARNINGS,
CAUTIONS AND IMPORTANT NOTICES
FS301 Flame Simulator
FS301 Safety and Technical Manual
3
Ref: 2301.6042
Rev: 2.3 ECN: 4553
