After sanding, glue the control horns in place.
Make note of which side is left and right.
The left side has a cut-out for a receiver.
The right side has a cut out for a battery.
Glue the wooden servo mount in place in the central
fuselage piece and make sure it is centered in the
foam sheet.
While the fuselage servo mount is drying, work on
the wheels. Glue the two sets of hubs together and
use the control linkages to get the center holes lined
up. Set aside and allow to dry while you continue
with the fuselage.
Glue in place the two side pieces. For these, just
apply the glue to the side piece and spread it out
thin. Then align it with the main centre piece of the
fuselage.
If you place it on very gently without pressing it
down, it will be able to be moved a little to get it in
the correct position. Note your alignment points
shown by the arrows. Make sure the pieces are flush
here.
Once it is positioned correctly, press firmly to set it
in place.
Cut out this piece which is
used to hold the left hand side
frame in shape while gluing.
Left hand side
Right hand side
