Glue on the nose cover sheets and make sure that
excess glue is cleaned out of the wing gap here before
it dries.
Sand the tail pieces at a small angle so when they are
put flush up against the side of the fuselage, they
form an upward angle.
Use some blue tack or masking tape to secure the
body to a flat surface and make sure it is exactly
vertical.
Then use the angle guide from the wing tips to set the
angle of the tail pieces as they are drying. The tail
pieces are glued to the side of the fuselage not to the
top. Make sure they are flush with the bottom of the
fuselage.
After they are glued on, run some more glue in the
crevice for additional strength.
