Glider V-Tail Bellbird
The bellbird is an easy to build glider for the beginner to intermediate level builder. The construction is straight
forward and all parts are pre cut to slot together easily. A limited amount of sanding is needed on the V-Tail
section before gluing in place.
The kit features dihedral on the wingtips and these sections are pre-cut so all you need to do is to bend them
upward, infuse some glue into the gap and allow to dry. We also provide an angle wedge which is used for the
tail and wing tips to achieve the correct angle while drying.
Your kit contains the following items
Pre- cut parts
Sandpaper sheets
Diagram sheet
Additional Items You May Need
* Cling Wrap
* Flat board (working surface)
* Hobby Knife
* Wood glue
* BlueTack or putty
* Tape
Build Procedure
Firstly it’s a good idea to tape down a sheet of cling wrap over your work surface. This will stop the parts from
becoming glued to the surface. It’s easier to peel off cling wrap from any wooden parts.
Bend up the win tip pieces a little but not enough to
completely detach them from the wing.
There is an angle guide included which can be placed
under the wing tip to hold it at the correct angle while
gluing.
