Before gluing the undercarriage mount in place
screw in the three positioning screws in place
which hold the wire frame in place. Check the
undercarriage is firm.
Then glue the undercarriage in place.
Glue in place the triangular support pieces as
shown here.
Mount the motor on the motor mount with the
supplied screws.
Put the supplied spacers under the rear of the
motor mount as shown here to give the motor
down-thrust. NOTE: Spacers included in the kit
are clear plastic – not red in colour as shown in
the image here.
You may wish to solder your connector (not
supplied with kit) to the motor leads before
mounting it on the airframe.
The motor mount has pre-cut holes which
accommodate 5320 servos. If you are using a
receiver and servo setup (not included with kit)
you can screw the servos in place. Cut holes as
needed in the airframe to route the servo wires
back to the receiver.
This micro receiver mounts nicely between the
servos.
