Glue in place the verticalstabiliser ensuring it is at right angles with the tailplane. Then glue the
tailplane onto the carbon body former and check it is straight. Add some extra glue around the
mount where the carbon rod passes through. Once again you may wish to rough up the carbon
where the tail attaches to allow the glue to adhere well.
Attaching the Motor
The motor is supplied with no connector. Depending on your
choice of receiver you may wish to solder the wires directly to
the receiver board or attach a connector which matches the one
on your receiver.
See the connectors section on our website for various options.
Link to Connectors page on MicronWings
Rough up the carbon body former with some sandpaper and
attach the motor by gluing it in place. Check it is straight with
the motor above the carbon body former. The motor will have
some degree of down thrust and this is needed for correct flight.
With this done your basic airframe is complete. You may need
to bend the undercarriage a little so the wheels sit flat on the
ground. You’re now ready to fit out the electronics and control
linkages.
