Glue these wing supports in place onto the carbon body spar and to the measurement and
spacing guide shown below. Use the wooden spacer to get the spacing between them exact
(image on right below). Also ensure it is flush with the end of the carbon rod. Make sure the cut-
out gaps in the wing supports are facing in toward each other. These gaps are where the wings
slot in. You may need to sand (burr) the end of the carbon rod with some sandpaper to make it
easier to slide into the holes in the wing supports.
It’s best to rough up the carbon rod where the supports will be glued with some rough sandpaper
if you have it or a hobby knife. This will assist the glue to stick to the carbon. Use either UHU Hart
(CA Glue) or UHU Por (tacky foam glue).
UHU Hart (
UHU Por (
Place the airframe upside down on a flat surface to align the wing supports and add a little glue
around the carbon body spar and onto the wing supports.
Flush
