Micron Xccela Flash MT35X, Быстрый старт

Страница: 6 / 8

CCM005-1718347970-10454
micron_xccela_zedboard_qsg.pdf Rev 0.1 4/19
6
Micron ® Xccela ™ Flash Quick Start Guide for ZedBoard ™
6
If this is the first time booting the ZedBoard, run the following two commands to
set up the system boot environment, and then power down the board.
Skip these
three steps if you’ve previously booted the ZedBoard .
•
Press any key when the message Hit any key to stop autoboot appears.
•
env default -f -a
•
env save
7
Power on the ZedBoard.
When the XCCELA>> prompt appears after the Micron welcome screen (it may take
a few seconds), the system boots successfully and enters the SPI NOR test bench.