Micron MC-20, Руководство пользователя, Страница: 37 / 37

MC-20
User Manual / Contact Informations
37/37
Contact Informations
** If you encounter issues not addressed by this user guide, please contact our
technical department for additional support at 973-278-4100 or email us at
service@micronamerica.com
Micron Group, Inc.
Address:
85-99 Hazel Street Paterson, NJ 07503
Telephone: +1-973-278-4100
Fax:
+1-973-278-4101
Caution
Do not use any of these machines without proper point of operation safe guarding. Do
not start or use any of these machines unless and until you have been fully instructed in
their use and are thoroughly familiar with all safety, operating, and parts handling
procedures. Under no circumstances should fingers, hands, or any parts of the body be
placed between the setting tools while the machine is in operating mode. Before
operating the machine, test by placing a finger-thick material to see if safety is working.
Always turn off the machine and air when you change the dies.
MC-20 Fastener Attaching Machine shipped to you was tooled and tested using a specific
grommet as indicated on the identification tag fastened to the machine. It may be
dangerous to use this machine for any assembly or purpose other than that for which it
was originally designed and built. Should this machine be retooled, appropriate safety
devices should be employed to meet the requirements of the new job. Consult
Micron
Group, INC. for recommendation on safety equipment required.