DMX512 Control Data Connection:
This fixture complies with international USITT DMX standards and can be used
with a 3 pin DMX connector. Plug in the 3 pin XLR cable to the female 3-pin XLR
output of your controller and the other side to the male 3-pin XLR input of the LED
battery par light. To connect the units to DMX, you must daisy chain the fixtures
together as referred in the diagram below. Always end your DMX-512 connection
with a DMX terminator
For installations where the DMX cable has to
run a long distance, or is in an electrically noisy
environment, it is recommended to use a DMX
terminator. This helps in preventing corruption of
the digital control signal by electrical noise. The
DMX terminator is simply an XLR a 120 120 Ω
resistor connected between pins 2 and 3, which is
then plugged into the output XLR socket of the last
fixture in the chain. Please see illustrations below:
Key Description
MENU:
Access the menu
DOWN
:
“reduction key” or “key under the
selected”; decrease the value
function down menu.
UP:
“add key” or “selection on the
key”; increase Lou = value
function, shift on the menu
ENTER:
“OK button”; to determine the
function into the user selected
(that is to stop the ongoing
functions, run the function the
user selected items
