Microh Ultra Sport 1200, Руководство пользователя

Страница: 6 / 22

LAMP ADJUSTMENT
REPLACING LAMP
CAUTION: ALWAYS SWITCH OFF AND UNPLUG AT THE MAINS BEFORE INSTALLING
THE LAMP
1. Disconnect the power and all the unit to cool for at least 10 minutes.
2. Loosen screws indicated A & B on the lamp cover at the back of the head.
3. Gently pull and remove the lamp cover and lamp holder from the head.
4. Holding the lamp by its ceramic base, carefully pull the lamp straight out of the lamp socket.
5. Holding the new lamp by its ceramic base, gently insert the lamp in to the lamp socket.
6. Reinsert the lamp cover and lamp holder and tighten screw A & B.
IMPORTANT:
Ø
Always make sure that the lamp is installed tightly into the lamp socket.
Ø
DO NOT install a lamp other than that specified in this user manual.
Ø
DO NOT touch the glass area of the lamp with bare hands.
When this product left the factory, the lamp holder was calibrated here. However, due to the
possibility of small deviations between lamps, fine adjustments after replacement may
improve light output.
1.
Turn on the lamp and operate with white beam (i.e. no effects)
2. Open the shutter and the iris with the dimmer intensity at 100%.
3. Focus the light beam on a flat surface (i.e. wall/floor)
4. Center the hot-spot (the brightest part of the image) using the 3 adjustment screws
X
,
Y
& Z .
5. Once the hot-spot has been centered, remove the hot-spot and balance the light
output by turning the adjustment screws a quarter-turn clockwise one after another. If the
hot-spot cannot be located, adjust the lamp until the light output is evenly distributed.
6. If the light output is brighter around the edge than in the center or if the light output is too
low, the lamp is too far back from the reflector. Turn the screws
X , Y & Z a quarter-turn
anti-clockwise one after another until the light output is evenly distributed.
Disconnect the fixture from AC power before re-lamping.
Lamp is hot! Risk of fire! Protect hands and eyes.
Wait at least 15min. before opening
the covers and removing
lamp from the fixture.
Lamp
Lamp holder
Fixed the lamp holder
of screw(A,B)
Adjust screw (X,Y,Z)
.5.
INSTALLATION