Microh Ultra Sport 1200, Руководство пользователя

Страница: 2 / 22

.1.
INTRODUCTION
This equipment is produced in accordance with CE standards and conforms to the
international standard DMX512 protocol.
On receiving this product, please carefully check that there has been no damage caused in
transportation and that the following parts are enclosed:
1 1200W SPOT MOVING HEAD
1 SIGNAL CABLE
1 USER MANUAL
1 SAFETY CABLE
2 CLAMPS
IMPORTANT
BEFORE OPERATION PLEASE CONFIRM THAT THE POWER SUPPLY STATED ON THE REAR
PANEL OF THIS UNIT IS THE SAME AS THE SUPPLIED MAINS POWER IN YOUR AREA.
READ THIS USER MANUAL CAREFULLY BEFORE OPERATION
SAFETY WARNING
Ø
This product must be installed by a qualified professional
Ø
All operation and maintenance must be carried out in accordance with this user manual.
Ø
Keep this device away from any form of water or moisture at all times.
Ø
Always disconnect the power before attempting to open the equipment housing or carrying
out any maintenance.
Ø
Avoid looking directly into the light source (especially those who suffer from epileptic fits)
Ø
DO NOT touch the equipment casing during operation due to high temperatures of the metal
and plastic housing.
Ø
This equipment is designed for indoor use only.
ATTENTION
Ø
This product left our premises in perfect condition. In order for safe operation and to
maintain the original condition, the user must always follow the instructions and safety
warnings described in this user manual.
Ø
The manufacturer cannot accept liability for any resulting damages caused by non-
observance of this manual or any unauthorized modifications to the equipment and are not
subject to warranty.
Ø
Always make sure that the equipment is OFF before connecting the power cables.
Ø
Always make sure that the power cable is never cut or damaged by sharp edges. It is
advisable to check the state of the power cable from time to time.
Ø
DO NOT connect this equipment to a dimmer rack.
Ø
This device falls under Protection Class I. Therefore it is essential that the yellow/green
wire must be earthed.
Ø
If during transportation or storage the equipment has gone through drastic temperature
changes, it is advisable to allow some time for the equipment to first adjust to room
temperature before operation.
Ø
Never turn on the equipment without a lamp
Ø
Avoid shaking of strong impacts to the equipment.