3
3. OPERATION INSTRUCTIONS
- Do not turn on the fixture if it has been through severe temperature differences. Damage may occur to the fixture. Wait
until unit is at room temperature to operate.
- The unit should be protected from any tremor or agitation during transport.
- Do not expose the fixture in any excessive heat, moisture or any environment with too much dust when installing. Do not
lay any power cables on the floor. It may cause electronic shock or damage to persons or equipment.
- Make sure to attach the safety chain and ensure the screws are properly screwed in when installing the fixture.
- Make sure the lens is in good condition. It is recommended to replace the unit if there are any damages or severe
scratches.
- Make sure the fixture is operated and installed by qualified personnel.
- Keep the original packaging in case of defective product.
- Any non-manufacturer additions, modifications or changes in any way will void all warranty.
- Please do not attempt to open unit. It is only to be serviced by an authorized technician. If this occurs, or is apparent, the
warranty will be voided.
- The fixture’s warranty will be voided if there are any malfunctions from not following the user manual or any illegal
operation (shock short circuit, electronic shock, lamp broke, etc.)
Manual Dimmer Colour Mode
1.
Press MODE button and select red dimmer colour (XXX). Continue pressing SET UP to choose different colour. Green
G(XXX), Blue b(XXX) or White u(XXX). Continue pressing SET UP to select strobe mode FS (XX) or the zoom mode
Z(XXX).
2.
Press UP or DOWN to adjust the intensity of the red, green, blue or white colour. 0-255 is the speed of the strobe in the
strobe mode and is also the beam angle from big to small in the zoom mode.
0-Off Strobe 1-Lowest Speed 15-Highest Speed
Static Colour Select Mode
1. Press MODE button and select CL (XX) for the static colour. Continue pressing SET UP to select strobe mode St (XX) and
the zoom mode Z (XXX).
2. Press UP or DOWN to select static colour 0-15, the strobe speed in the strobe mode and the beam angle from big too small.
0-Off Strobe 1-Lowest Speed 15-Highest Speed
Auto-Run Program
Two Auto-Run programs are built into the LED Max Zoom Quad – Colour Snap program (AJ-X), Colour Mixing (AF-X).
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
Z
