9. Align the pin of the top hinge with top hole on the left side of the door
and push into place. Replace the screws in the upper hinge bracket
but do not tighten all the way. (see fig. # 2)
10. Make sure the door closes easily but forms a tight seal. Adjust the
door as needed. Once you are satisfied with the door alignment,
completely tighten the upper door hinge screws.
11. Replace the hinge cover. (see fig. # 2)
12. If the door does not close properly, refer to the section titled
“Door Alignment”.
Note
: As the door gasket gets pressed-in during shipping, after reversing
the door the gasket may have to be reset. This is done to prevent
the cool refrigerated air from escaping. If there is a gap between
the door gasket and the cabinet, set the gasket by gently pulling it
out to seal the gap.
fig. # 3
door pin
lower hinge bracket
screw hole plug
9
English
