Microframe Corp
Page 6
D8010 Manual r1.1
Setting the time and changing the settings
Setting Start Time:
To set the start time simply press and hold both the “Mode/ON” and “+” buttons for 3
seconds. Once in the time set mode, the display will stop counting and await your input. From this point you can
quickly set each digit on the display. Simply press “+” or “-“ to increment or decrement the digit and “Mode/On”
to move to the next digit. Press and hold “Mode/On” to save and exit or do nothing for 10 seconds to time out
and exit without saving.
NOTE:
The display always starts at zero when a new battery is inserted.
Changing the settings
To enter program memory mode: hold both [Mode/On] and [-] buttons. Use the [On] button to select an option.
Use the [+] and [-] buttons to change a value. Press and hold [ON] button to exit. Options are retained even if the
battery is removed.
1)
Sleep: How long before the screen blanks. 5-60 seconds.
2)
Frame Rates: 23.98 (23.976), 24, 25, 29.97, 29DF (drop frame), 30
3)
Percent brightness for the display. Running at a high brightness will shorten the battery life. 5-100%.
4)
Flip the display direction. Note: the frame count ends up on the top row. (D8010 only)
Set Sleep Time:
The sleep time is actually how long the time is shown when the “on” button is pressed
before the display goes back to it’s off state, to conserve battery. The factory default is 15 seconds. You can
change this from 5 to 60 seconds. Simply press and hold “on” and “-“ to get into Options mode. The display will
show “SLEEP”. Simply press “+” or “-“ to change the value, then press and hold “on” to save settings.
Set Frame Rate:
The available frame rates on the Sync Master are: 23.98 (23.976), 24, 25, 29.97, 29DF (drop
frame), 30. To set the frame rate simply press and hold “on” and “-“ to enter Options mode. The display will
show “SLEEP” as that is the first setting. Press the “on” button to advance to the “rate” setting. From here press
“+” or “-“ to scroll to the desired frame rate, then press and hold “ON” to save the setting.
