Microframe Corporation
Series 190 Visual Pager
DETAILED VISUAL-PAGER CONNECTION
STEP 1:
Remove slide-on cover.
STEP 3:
Insert Black Wire in one of the
terminals marked GND.
Insert Red Wire in one of the
terminals marked SIG.
Tighten terminal screws using a
1/8" slotted screwdriver.
STEP 4 (If required):
If a second set of wires are
required at the Keypad,
repeat Step 3 being careful
not to reverse the SIG and
GND connections.
STEP 2:
Remove 1.5" insulation from cable
jacket and separate wires.
Strip 1/4" insulation from each wire
and pre-form wires as shown.
STEP 5:
Install slide-on cover being careful
to ! rst form wires so the Ty-wrap is
inside the case as shown. The slide-
on cover has a notch for the wires to
