Microcom 334M, Руководство оператора

Страница: 98 / 237

Chapter 5 Printer Commands
334M Operator’s Manual - 880060-0110 5-16
8 Finish Mode: When enabled, the printer will finish printing the current label
as far as it can after a stock out error. The change will take place after a power
cycle or after the restart command. When a stock out occurs the printer will
finish printing the entire label if the LSY is less than the dot-to-gap distance. If
greater, it will continue printing for a distance equal to the dot to gap distance
OR until the label finishes; which ever comes first. The dot-to-gap value is
configurable using the D158 command. The error will be acknowledged at the
end of printing. This will work with all media (continuous, black line, and gap).
1 = Enable Finish Mode
0 = Disable Finish Mode
5.2.1.8
Software Switch #8
^AB ^D COMMAND
XX 28 Change SW8: Software Switch #8.
^AB12345678 ( each bit is represented by a numeric position number)
Position:
1
Reserved
2
Reserved
3
Line Feed: This feature is used to control the line feed. When enabled, the
printer will line feed while the button is pressed and held. When this feature is
disabled, pressing and holding the button will be ignored.
1 = Disable Custom Test Ticket
0 = Enable Custom Test Ticket
4, 5
Reserved
6
Reserved
7
Reflective Stock Out Detection: When this feature is enabled, the printer
will use reflective sensor to detect stock out conditions. This should only be
used if a Transmissive sensor is not available.
1 = Enable Reflective Stock Out Detection
0 = Disable Reflective Stock Out Detection
8 LTS Jam Detection: This feature uses the printer’s Label Present or Label
Taken sensor to identify a jam condition after sending a print job to the printer.
When enabled, the printer will report the >LPD STOCK JAM< message if the
printer was sent a print job and the LTS did not detect the media exiting the
printer.
1 = Enable LTS Jam Detection
0 = Disable LTS Jam Detection