PICDEM™ 2 Plus User’s Guide
DS51275B-page 6
2004 Microchip Technology Inc.
2.2
PICDEM 2 PLUS USED WITH AN IN-CIRCUIT EMULATOR OR
IN-CIRCUIT DEBUGGER
To use PICDEM 2 Plus with an In-Circuit Emulator (ICE) or In-Circuit Debugger (ICD),
refer to the tool’s user guide for instructions on how to power-up and configure the
ICE/ICD, as well as how to connect to target boards (e.g., Figure 2-1).
FIGURE 2-1:
PICDEM 2 PLUS CONNECTED TO MPLAB ICD 2 USING USB
Configure the PICDEM 2 Plus for the desired oscillator as described in Table 2-1. Refer
to the ICE/ICD user’s guide for any oscillator configuration requirements.
TABLE 2-1:
OSCILLATOR SELECTION
Oscillator Selection on
PICDEM 2 Plus
Modification on PICDEM 2 Plus
RC
J7 installed, Y2 empty, Y1 empty
Crystal
J7 removed, Y2 empty, crystal in Y1, caps in C4 and C5
Canned Oscillator
J7 removed, oscillator in Y2 (Y1, C4, C5 empty)
Resonator – no internal caps
J7 removed, Y2 empty, resonator in Y1, caps in C4 and C5
Resonator – with internal caps
J7 removed, Y2 empty, resonator in Y1, C4 and C5 empty
