Microchip Technology PIC32CM LE00, Руководство пользователя

Страница: 17 / 29

Table 4-11. Digital High (J503)
J503 Pin
(SHIELD_DIG)
MCU Pin Function Shared Functionality
1 [D8] PC11 GPIO -
2 [PWM/D9] PC12 GPIO -
3 [PWM/D10] PA10 GPIO EXT1
4 [PWM/D11] PA08 SERCOM2/PAD[0] SPI MOSI EXT3
5 [D12] PA11 SERCOM2/PAD[3] SPI MISO EXT1
6 [D13] PA09 SERCOM2/PAD[1] SPI SCK EXT3
7 [GND] - GND -
8 [AREF] PA03 ADC / DAC VREFA EXT1
9 [SDA/D14] PB30 SERCOM5 PAD[0] I²C SDA EXT1, EXT2, EXT3, mikroBUS, EDBG DGI
10 [SCL/D15] PB31 SERCOM5 PAD[1] I²C SCL EXT1, EXT2, EXT3, mikroBUS, EDBG DGI
Table 4-12. SPI (J502)
J502 Pin
(SHIELD_DIG)
MCU Pin Function Shared Functionality
1 [MISO] PA11 SERCOM2/PAD[3] SPI MISO EXT1
2 [5V] - VCC_P5V0 -
3 [SCK] PA09 SERCOM2/PAD[1] SPI SCK EXT3
4 [MOSI] PA08 SERCOM2/PAD[0] SPI MOSI EXT3
5 [RESET] /RESET TARGET_RESETN EDBG SWD, Cortex Debug, PICkit 4 Interface, RESET
button
6 [GND] - GND -
4.2.5 MCU Current Measurement Header
An angled 1x2, 100 mil pin-header marked with CURRENT MEASUREMENT is located at the upper edge of the
Curiosity Pro. All power to the PIC32CM LE00/LS00/LS60 is routed through this header. To measure the power
consumption of the device, remove the jumper and replace it with an ammeter.
Table 4-13. MCU Current Measurement (J203)
Current Measurement Header Pin Function
1 -
2 VCC_MCU_P3V3
CAUTION
Removing the jumper from the pin-header while the kit is powered may cause the PIC32CM LE00/LS00/
LS60 to be powered through its I/O pins. This may cause permanent damage to the device.
PIC32CM LE00/LS00/LS60
Hardware User Guide
©
2022 Microchip Technology Inc.
and its subsidiaries
User Guide
DS70005443E-page 17