PolarFire MPF300T FPGA Video Kit
50200872 UG0872 User Guide Revision 1.0
15
Figure 13 • XCVR2 Interface
4.8.4
XCVR Reference Clock
The following figure shows the clock sources for XCVR blocks.
Figure 14 • XCVR Reference Clocks
XCVR 1A, 3A reference clocks are sources from FMC HPC connector(J14).
XCVR 2B reference clock is sourced from the on-board 148.5 MHz
XCVR 2A reference clock is sourced from the on-board HMDI2.0 TX
4.9
Programming
The PolarFire device is programmed using the on-board FlashPro5 programmer or through the JTAG
Header. For more information about programming, see the
The following section describes the FTDI and JTAG Header programming schemes used on the board.
4.9.1
FTDI and JTAG Header Scheme
The PolarFire device can be programmed using the on-board JTAG Header or FTDI. By default, the FTDI
programming mode is enabled. The programming mode can be changed based on the Jumper settings.
For more information, see
.
Table 3
