Microchip Technology MCP19117, Руководство пользователя

Страница: 18 / 42

MCP19117 Flyback Stand-Alone Evaluation Board User’s Guide
DS50002472A-page 18

2016 Microchip Technology Inc.
2.5 REPROGRAMMING THE MCP19117 FLYBACK STAND-ALONE EVALUATION
BOARD
Perform the following steps to install necessary software and begin reprogramming the
MCP19117 device:
1. If MPLAB X IDE is already installed, go to Step 2. If not, download MPLAB X IDE
from: www.microchip.com/mplabx , and follow the installation instructions.
2. If the MPLAB XC8 C Compiler, or a compatible equivalent, is already installed in
MPLAB X IDE, go to Step 3. If not, you can download a free version of the
MPLAB XC8 C Compiler from:
www.microchip.com/mplabxc . The user guide,
installation instructions, and download links are available on the web page.
3. Download the MCP19117 - Flyback Stand-Alone Firmware
(ADM00663_02_10403_U1-R2_Firmware.zip) from
www.microchip.com/mcp19117 under "Documentation".
4. Unzip the MCP19117 - Flyback Stand-Alone Firmware archive. Place the
MCP19117 project folder in the desired folder location.
5. Power-up the MCP19117 Flyback Stand-Alone Evaluation Board.
6. Connect the PICkit 3 In-Circuit Debugger to the MCP19117 Flyback Stand-Alone
Evaluation Board via the 6-pin connector J3, as seen in Figure 2-3 . For more
information about PICkit 3 In-Circuit Debugger refer to the PICkit™ 3 In-Circuit
Debugger/Programmer User’s Guide For MPLAB® X IDE (DS52116).
FIGURE 2-3: PICkit 3 In-Circuit Debugger/Programmer Connected to the
MCP19117 Flyback Stand-Alone Evaluation Board.
Note: When installed, MPLAB X IDE automatically creates a project folder. In
Windows, this folder is typically located under
drive\Users\ user_name \MPLABXProjects
.