Figure 5-2. Attaching Pin-Headers to the Curiostiy Nano Board
Figure 5-3. Connecting to Curiosity Nano Base for Click boards
™
Tip:
Start at one end of the pin header and gradually insert the header along the length of the board.
Once all the pins are in place, use a flat surface to push them in.
Tip:
For applications where the pin headers will be used permanently, it is still recommended to solder
them in place.
Important:
Once the pin headers are in place, they are hard to remove by hand. Use a set of pliers and
carefully remove the pin headers to avoid damage to the pin headers and PCB.
5.2
Peripherals
5.2.1
LED
There is one yellow user LED available on the PIC18F16Q40 Curiosity Nano board that can be controlled by either
GPIO or PWM. The LED can be activated by driving the connected I/O line to GND.
Table 5-1. LED Connection
PIC18F16Q40 Pin
Function
Shared Functionality
RC1
Yellow LED0
PIC18F16Q40 Curiosity Nano
Hardware User Guide
©
2020 Microchip Technology Inc.
User Guide
DS50003047A-page 26
