message content contains 0x11, 0x01, 0x33, 0x44, 0x44, 0x55.
Please refer to the configuration instructions for how to use the appeal action.
3.Installation Instructions
Installation Orientation:
The antenna surface of the radar module (flat surface) is facing to the
detection area, with the heat sink facing up, and the angle could be slightly
adjust vertically and horizontally. And the connector should go out to the right.
Figure 1. Schematic diagram of radar installation direction
Installation Location:
It is recommended to install the radar the downside of the front bumper bar
and keep it from 0.5 meter to 1.0 meter above the ground. If the available
installation height is less than 0.5 meter, the installation pitch angle should be
adjusted appropriately. The installation position is near the mark position in
front of the vehicle. Customers could reserve the installation hole position or
make the installation bracket for different models.
