9
Wine Saver HOME has been designed for simple set-up and
ease of operation. If you are having a problem with your
system, the following suggestions will likely guide you to a
solution.
WINE SAVER HOME TROUBLESHOOTING GUIDE
Some taps are flowing wine and others are not:
Simply disconnect the Quick Connect coupler and
reinstall, making sure the coupler is properly seated.
■
Always preserve a full bottle of wine.
Preserving a previously opened bottle of wine that
is not full may result in decreased performance from
your system. Always begin preserving with a full bottle.
■
No wine is flowing from any of the Taps:
Make sure WSH Argon Gas cylinder has been completely
threaded in and is completely seated, or replace WSH Argon
Gas cylinder as it may be empty.
■
You cannot get wine to flow after the above
troubleshooting steps.
Please contact Wine Saver HOME at 610-435-5240 or
toll free at 877-601-9463 for further assistance.
■
Excess wine is remaining at the bottom of the bottle
after service:
Disconnect the Quick Connect coupler, take Tap Head /
Draw Stem assembly out of bottle neck, and adjust the
Draw Stem so that it is sitting on the bottom of the
wine bottle. (Refer to Page 3)
■
After using for some time, you notice you are not
getting 12 to 15 bottles (approximately) of wine per
WSH Argon Gas cylinder:
1. Disconnect all Quick Connect couplers.
2. Remove the Tap Head / Draw Stem assemblies.
3. Soak assemblies in hot water for a few seconds.
Remove one Tap Head at a time and spread out the
bottle seal fins to their original state.
(fins should be perpendicular to body of Tap Head)
4. Replace Tap Head / Draw Stem assemblies and
re-connect Quick Connect couplers.
■
Note: Always disconnect Quick Connect couplers
before changing bottles.
Note: There may be a slight amount of wine remaining in
the Tap Head nozzle after pouring. This is common with all
spigot based systems and is part of normal operation.
Note: Wine Saver HOME is equipped with a patented
regulator assembly with a relief valve designed for safety.
If you attempt to remove a cylinder that still has gas in it,
you will hear a pressure relief puff or whistle.
Warranty Note: Wine Saver HOME is designed specifically
for use with WSH Argon Gas as its preservative, use of any
other preservative will void the manufacturers warranty.
Содержание Wine Saver HOME
Страница 1: ...OPERATIONS MANUAL...
