Micro Matic smartDRAFT, Руководство по эксплуатации

Страница: 18 / 20

18
8. Faults and remedies
Type of fault Possible causes Remedy
smartDRAFT Dispense the front part of the smartDRAFT Dis- attach the smartDRAFT Dispense Head
Head does not fi t on the pense head does not lie in the cut-out so that the front part fi ts in the cut-out
smartDRAFT KEG in the top ring of the smartDRAFT KEG of the top ring
the smartDRAFT Dispense Head completely withdrawn the smartDRAFT
was not attached completely withdraw Dispense Head and attach it on the KEG
smartDRAFT TAP is not smartDRAFT TAP is not attached please refer to instruction on
working properly page 9
too much foam smartDRAFT KEG has not been pre-cool smartDRAFT KEG and
pre-cooled pay attention to LED display
and wait until the KEG has reached
8°C.
drink is too warm dispensing temp. not yet reached wait until LED Display has reached
8°C
door of smartDRAFT Cooler are close door until you hear locking
not properly closed clip click into place
smartDRAFT KEG has not been pre-cool smartDRAFT KEG and,
pre-cooled
cooling fan motor dirty or defective inform service technician
ventilation grille is covered uncover grille
unit placed too close to a wall ensure suffi cient distance
refrigeration circuit leaks or the inform service technician
compressor is defective
compressor does not work compressor is not switched on inform service technician
or is defective
cooling fi ns in the door of smartDRAFT Cooler are remove the plug from the power
smartDRAFT Cooler are not properly closed supply, allow the fi ns to defrost.
covered in ice Mop up any moisture with a soft
cloth. Always close the door
smartDRAFT Cooler has been remove the plug from the power
operated without a KEG supply, allow the fi ns to defrost.
Mop up any moisture with a soft
cloth. smartDRAFT Cooler
may only be operated with a
smartDRAFT KEG