MICRO-EPSILON colorCONTROL MFA-1, Инструкция по эксплуатации

Страница: 30 / 36

Page 30
Operation and Settings
colorCONTROL MFA-1
Sensor Monitoring 6.9
If the signal received by the sensor receiver is too weak due to contamination or a sensor fault, the symbol
will light up.
Setting the Timer 6.10
i
The timer can only be enabled in setup mode.
Press the button for 4 seconds until the symbol starts blinking.
Use the and buttons to increase or reduce the value.
First press of the button t = 40 ms
2 - 11
t = +500 ms
The
t
symbol starts blinking when t > 0 ms.
Press the button once to set the timer to 0.
Drop-out or Pick-up Delay 6.11
i
After setting the timer you need to select the type of delay.
Default setting: OFF delay = drop-out delay
If you keep the button pressed for 4 seconds, the delay type changes to ON delay = pick-up delay.
Repeat this step to change back to OFF delay.
Press the button again to return to operating mode.
Δ
SET
t
Lo-Do
SET
t
SET
t