Micrel Confidential
3
June 2006
KSZ8862-16 MQL Demo Quick Start Guide
Figure 2: Parameters Settings on the Hyper Terminal
Normally the Hyper Terminal window will display as shown in Figure 3 after the demo board is
powered up or reset.
Figure 3: Hyper Terminal Display after Powering On the Demo Board
In this window, hit “Enter” and type “=>hwhelp” to show all commands and parameters that can
read/write from/to registers, configure the chip, display MIB counters and send packets, etc.
From this window, the software has assigned the IP and MAC addresses in the Demo Board.
IP Address: 192.168.1.1 and Switch Host MAC Address: 08-00-70-22-44-55
