Michigan Pneumatic Tool 750SS Series, Руководство пользователя

Страница: 10 / 28

10
Lubrication
1. Each time a tool is dis-
assembled for maintenance
or repair, the tool must be
lubricated.
2. Work approximately 15 cc
of Mobil Mobilux EP2 Lithium
Grease into the Impact
Mechanism.
3. Generously coat the Anvil,
Hammers and Hammer Case
Bushing with grease while
assembling.
4. Coat the vanes with Marvel Air
Tool Oil before sliding them into
the rotor.
5. For routine maintenance, inject
4-5 cc of grease into the grease
fitting (750SS-15) using a low
pressure grease gun after every
40 hours of run time.
6. Apply 6-8 drops of Marvel Air
Tool Oil into the inlet prior to and
after each use
(see figure 10.2).
Air Supply
1. Always use clean, dry air
at 90 psig (6.2 bar/620kPa)
maximum air pressure.
2. Be sure all hoses and fittings
are the correct size and are
secured tightly.
3. Always use a Filter, Regulator,
Lubricator
(see figure 10.1).
Maintenance
Compressor
Air Tank
Air
Dryer
Main
Pipe
Valve
Higher than
1/100 inclination
Pressure
Regulator
Drain
Tank
Filter
Bigger Hose Better
Figure 10.1
Figure 10.2