Rev: 19/September/2017
Step 7.1: Rocker Switch Electrical Installation
Note
:
Apply the supplied Dielectric Lubricant to all wire connections when each wire is hooked up. The Dielectric
Lubricant will help to prevent corrosion.
Procedure:
Mount the rocker switch in an obstruction free area inside the truck cab. Mount the solenoid on the
truck near the cab/batteries. Run the #6 double strand wire from the solenoid along the truck frame to the rear
box hinge point. Now run the wires along the box frame to the front box sill. Leave a slight amount of slack at
point (G) and continue running the wire along the pivot arm. Secure the wire to the top pivot arm (I) with the tie
straps provided. Attach the wire to the truck with the wire clips and 1/4"x1" self-tapping screws that are provided.
Connect the wires to the motor posts. The ends at the solenoid both get a black rubber boot and a #6-1/4" stud
crimped on.
Step 7.1: Rocker Switch Electrical Installation Cont.
Run the 14-3 wire from the solenoids to the rocker switch. At the switch each wire gets a 14G female end crimped
on and at the solenoid each wire gets a 14G female end except for the wire connected to the middle post of the
switch gets a 14G-1/4" ring terminal crimped on to connect to the positive post of the
solenoid. Follow wiring
Schematic below, raise and lower the hoist to make sure that the wires are free from obstructions. Run #6 wire
from the solenoid to the battery posts. The wire with the red stripe will be the positive wire and will get bolted on
the positive post marked (+) along with the black 14Ga wire running from the switch. The black wire or negative
wire will be bolted onto the bottom negative post (-).Put the 50A circuit breaker in line with the positive wire.
Once everything is wired secure the motor cover to the motor with the 2 self-tapping screws provided.
ROCKER SWITCH
50AMP
CICUIT BREAKER
HEAVY DUTY REVERSE
DC CONTACTOR
BATTERY
NEGATIVE (-)
BATTERY
POSITIVE (+)
WIRE LEADS
TO MOTOR
