Rev: 19/September/2017
Step 5: Electric Motor Installation
Note:
The front beveled cable pulley (A) is stamped
FRONT STANDARD
and the rear beveled pulley is stamped
FRONT REVERSE.
Procedure:
Mount the motor (B) to the electric bracket (C) with 5/16"x3/4" hex bolts and lock washers as shown.
Slide the motor assembly into the front of the roll-tube and swing the arm down in-between the box and the cab.
Drill a 5/16" hole through the roll-tube and the predrilled hole in the motor shaft, approximately 1" from the
bracket. Secure together with a 5/16"x2-1/4" hex bolt and jam nut. The 1/4"x3/8" set screws in the front and rear
beveled pulleys are to be
tightened in Step 10.
Step 6: Pivot Arm Installation
Procedure:
To locate the pivot point on the front of the box, make a mark on the bottom sill of the box in the
middle of it. Note: Drill a 3/8" hole at pivot point (G) and slide the 1" round tubing (D) into the tubing on the
electric bracket (C). Secure the bottom tubing to the box with a 3/8"x4_1/2" hex bolt, 3/8" washers and nylon lock
nut.
