Michaelis Maschinenbau KM 20 T, Инструкция по эксплуатации/Перечень запасных частей

Страница: 6 / 50

- 6 -
MICHAELIS
m a s c h i n e n b a u
5. Attachement
A professional attachment has to be carried out by qualified staff.
Pay attention to the attachment specifications of the carrier vehicle manufacturer and the
road traffic act concerning: track protruding parts / distance steering wheel center to front
edge of attachment.
When attaching the machine it has to be further taken into account that all adjustment
options can be used in every operation position (clearance).
The fulcrums have to be well greased and must move smoothly.
6. Start up
The Weed machine needed to operate a hydraulic control circuit.
The drive of the machine is achieved on the hydraulic system of the carrier vehicle.
The hydraulic hoses are connected with the terminals on the carrier vehicle.
The working pressure is 160 bar.
6.1
Typ KM 20 T / TS (with hydraulic cylinder the brush head tilt)
With the help of change-over valves of the main frame during the brushing operation can on
or off (-2S1) are driven and the "tendency of the brush head" (-2S2) be set.
To select serves a mini control panel see 7.1.
The control desk is equipped with 1 cable connection.
Plug –X01 is designated for the connection on the on-board power supply from carrier vehicle.
The telescoping of the main frame with brush and the tilting of the brush head is provided
by a hydraulic cylinders.
The oil flow is required at
KM20T mind.: 25-30 l/min. (OMS-125)
KM20TS mind.: 35l/min. (OMS-200)
WICHTIG
Tight fit of the connector and hydraulic hoses to
look out for
Plug – X01 Connection to the
on-board power
supply
Picture 1