Micanan Pro-APTC, Инструкция по установке и эксплуатации

Страница: 19 / 32

19
DIPSWITCH SETUP
STATUS LED
Dip-Switch ON OFF NOTE
SEQ/COM Single button and radio in SEQ
mode
Single button and radio in
COM mode
Mid-stop timer Timer is enabled from mid-stop
only
Timer is enabled from both
mid-stop and full open
T or TS mode must be selected
to enable a timer for mid-stop
Delay on reverse Delay on reverse is 1.5 seconds Delay on reverse is 0.5 seconds Micanan recommends 1.5 sec
delay on reverse for all applica-
tions
Motor direction Reverse motor direction Standard motor direction See Note ** below
LED Status Cause
Fault ON - Primary safety devices not connected to P1 &
P2 or not functioning properly
- Safety devices are activated
- 10k Ohm resistor (between S1 & S2) removed
or faulty
Fault Blinking - Interlock is activated.
- Interlock jumper is not connected.
Run-out timer ON - Run-out timer has elapsed
Delay on close timer Blinking - Delay on close timer is counting.
- Selector dial is set to Run-timer.
Timer to close Blinking Timer to close is counting.
Safety/Photo ON - Primary safety devices not connected to P1 &
P2 or not functioning properly
- Safety devices are activated
- 10k Ohm resistor (between S1 & S2) removed
or faulty
Mid. Stop ON Door is at Mid-stop position.
Close Limit ON Close limit switch is activated.
Open Limit ON Open limit switch is activated.
Stop PB ON
OFF
- Stop button connected and functioning
- Stop push button is activated (or the stop
circuit is open).
Close Relay Blinking - Door is closing.
- Close relay is activated.
Open Relay Blinking - Door is opening.
- Open relay is activated.
Power ON 24 VAC power to logic board is ON.
NOTE: If motor direction is reversed, the open and close limit switches are automatically reversed. However, the advanced close limit
switch needs to be manually changed. To do this, disconnect the 2 wires from the advanced closed limit switch and re-connect to the
auxiliary limit switch provided.