1
2
3
4
5
6
7
8
9
11
12
13
14
IL-6400 lamp disassembly and assembly
1. Remove the charging contacts on the bottom of the lamp (open Phillips screws).
2. Open the six hex socket screws (2.5 mm hex key) and remove the lens frame, lens and seal.
3. Open the hex socket screw (3 mm hex key) and lift the reflector out.
4. Open the six hex socket screws (2 mm hex key) and open the aluminum frame slightly and
carefully disconnect the black/red wire connector from the LED circuit board. Pay special attention
to not touch any of the 4 LEDs on the circuit board.
5. Slide the carriage unit halfway out of the enclosure (if the carriage is stuck, tap the lamp gently
against the edge of a table) and disconnect the pushbutton connector. Pull the carriage completely
out of the cover.
6. Replace components as necessary and assemble in reverse order.
a. Avoid pinching any wires.
b. Be careful that the reflector does not come into contact with the LEDs during assembly.
MICA IL-640
1
2
3
4
5
6
7
10
11
12
13
14
8
MICA IL-6400
