OPERATING TIMES
The operating time with a fully charged battery depends on the lamp model and the operating mode
used (see table).
MICA IL-640, IL-640 EM, IL-6400 User Manual
The series of red LEDs under the handle show the battery charge. If only one LED is on and/or
the lamp begins to flash approximately every 15 seconds, the lamp battery is almost empty (10–20
minutes remaining). The control electronics will automatically turn off the lamp prior to deep discharge
of the battery. In an emergency, the lamp can still be used for a short period of time, but the battery’s
service life will be reduced.
The operating time will become shorter as the battery ages. If the overall operating time remains clearly
below the values stated in the table even with a fully charged battery, the battery should be replaced.
TO BE TAKEN INTO ACCOUNT WHEN USING LAMP
In case of NiCd batteries, in order to guarantee the longest service life possible, the battery should be
discharged completely from time to time by leaving the lamp on until it automatically shuts off. Lamps
equipped with NiCd batteries should be discharged fully approximately once a month. This helps to
avoid the battery memory phenomenon that reduces operating time.
Please note that you may not
install an NiMH battery in an NiCd lamp!
CHARGING AND STORAGE
Do not charge IL-640 & IL-6400 lamps in charging stands other than the new MICA ILC4. Older MICA
charging stands will not charge the lamp correctly, but can be upgraded to be suitable (contact your
dealer for more information). IL lamps should be stored in their stands while not in use. Please read
the charger manual as well!
CHARGING TIMES
IL-640 NiMH 11 h
IL-640 NiCd 7 h
IL-6400 NiMH 11 h
MAINTENANCE
During the warranty period, components may be replaced by an authorized ATEXOR service agent
only. Only original ATEXOR spare parts may be used. Other procedures will invalidate the warranty.
IL-640 lamp disassembly and assembly
1. Unscrew the charging contacts on the bottom of the lamp (Pozidriv 2).
2. Unscrew the locking ring, remove the lens and seal.
3. Open the hex socket screw (3 mm hex key) and lift the reflector out.
4. Carefully disconnect the connector from the LED circuit board. Pay special attention to not touch
any of the 4 LEDs on the circuit board.
5. Open the Torx (T20 key) screws and remove the LED module.
6. Slide the carriage unit halfway out of the enclosure (if the carriage is stuck, tap the lamp gently
against the edge of a table) and disconnect the pushbutton connector. Pull the carriage completely
out of the enclosure.
7. Replace components as necessary and assemble in reverse order.
a. Avoid pinching any wires.
b. Be careful that the reflector does not come into contact with LEDs during assembly.
c. Carefully insert the o-ring seal back in the groove and then place the lens over the o-ring.
d. The locking ring should be tightened while in the charging stand in order to ensure sufficient tightness.
IL-640 NiMH
LOW POWER
FULL-POWER
IL-640 NiCd
16 h
5 h
IL-6400 NiMH
24 h
5 h
24 h
8 h
