Prodomus
25
upwards) to fix the comb attachment in this setting. The level 1 is for
cutting without the attachment.
O
O
p
p
e
e
r
r
a
a
t
t
i
i
o
o
n
n
PREPARATION:
We recommend to wash the hair first and to cut it after having it towel-
dried and combed through. Position the person for hair cut in a way,
that the head is at your eye level.
Before cutting comb the hair so that it falls naturally.
Hold the hair clipper relaxed but ensure that it is always under
maximum control.
Now the appliance can be switched ON in two directions.
When you push the ON/OFF switch slightly upwards, the thin out
function (plastic blade in front of the cutting blade) will be switched
on also. If you push the switch slightly in the opposite direction
(downwards) you will cut hair without the thin out function.
Middle position of switch is “OFF”.
CUTTING:
Its recommended to cut with the attached length attachment using the
“biggest” length, when trying to cut for the first time. Unlock the length
attachment by sliding the cutting length locker switch (11) to "Unlock".
At first set the length of cut to 20 mm. Fix the cutting length at this
setting by moving the cutting length locker switch back to "Lock".
Repeat the procedure each time the length of cut is re-set.
Switch on and start trimming the hair beginning with the side of the
head. Move the hair clipper slowly from the bottom upwards. Gently
put the clipper against the hair, the front of the length attachment facing
upwards. Hold the appliance in a flat position to the head. Slowly move
the clipper upwards along the head, cutting a small amount of hair only.
Repeat on the other side and the backside of the head. If desired to cut
