Mi STYTJ01ZHM, Руководство пользователя

Страница: 8 / 95

Routine Maintenance
Wheel
Axle
Holder
Side Brush
Note: It is recommended to clean the side brush monthly and replace every 3 to 6 months.
1. Flip the vacuum-mop over, then gently pull out the side brush as
shown in the diagram below to clean it.
2. Reinstall the side brush.
Mop Pad
Note: The mop pad should be cleaned after each use.
1. Pull the mop pad off of the mopping module to remove it.
Omnidirectional Wheel
Note: The wheel can be cleaned with water and reinstalled after drying.
1. Flip the vacuum-mop over and pull out the omnidirectional wheel.
2. Remove hair, dirt, and other debris from the wheel and axle.
3. Reinsert the wheel and press it firmly back into place.
Note: Filter must be fully dry before use (allow at least 24 hours).
3. Remove the filter as shown in the diagram, forcefully shake it to
remove excess water, then place it aside to dry before reinstalling it.
Cliff Sensor
Charging Contacts
Movement Sensor
Infrared Deceleration
Sensor
Vacuum-Mop Sensors
Use a soft cloth to clean all sensors in the vacuum-mop, including:
· The four cliff sensors on the bottom.
· The infrared deceleration sensor on the front.
· The charging contacts on the bottom.
· The movement sensor on the bottom.
Note: Remove the pad from the mopping module before cleaning it, and make sure dirty water
does not flow back into the water outlet to avoid clogging. Do not press too hard on the mop pad,
as this can hinder its performance. Pad should be cleaned before each use. It is recommended to
change the mop pad every 3 to 6 months.
2. Clean and dry the mop pad.
13 14