Propane Patio Heater Manual
9
ASSEMBLY FOR MH-0040-PM10 (BEFORE SERIAL # 5450 1014 00001)
ASSEMBLING THE HEATER
Note: Tools required: 7/16" Wrench, 3/8" Open End Wrench, Adjustable opening
Wrench 8" long, Phillips screwdriver
1.
Attach post to base assembly.
Attach the Post to the post mounts
using M5 x 12 Bolts (6 pcs).
2.
Attach cylinder cover.
Attach the Cylinder Cover to the post mounts.
3.
Attach the upper pole to the lower pole
by four M4 x 8 bolts.
4.
Attach head assembly to post.
Load Head Assembly by inserting
Gas Hose into Post. Insert Head Assembly into Post. Tighten securely
using M5x12 Bolts (4 pcs).
5.
Assembly of reflector.
Attach Reflector Cap to top of reflector (4
pcs) using the M6 x 10mm Bolts (12 pcs), 6mm Washers (12 pcs)
and M6 Nuts (12 pcs) as shown.
6.
Attach the reflector
assembly to top of head assembly, Load the
Reflector Assembly to the top of the Head Assembly using M6 x 10
(3 pcs), 6mm Washers (3 pcs).
7.
Connect gas line to LP cylinder.
Attach Gas Hose to the Regulator
with 3/8” open end wrench and adjustable wrench, then fix it iwth
the fixing chain. Attach Regulator to LP cylinder. Tighten securely,
then move LP cylinder to the plate of the Base assembly.
8.
Check for leaks.
All factory connections of your Patio Heater have
been checked. To check the connections of the Gas Hose / Regulator
/ LP cylinder:
1. Make leak test solution by mixing 1 part liquid dish soap and 3
parts water.
2. Spoon several drops (or use a squirt bottle) of the solution onto
the Gas Hose/Regulator or the Regulator/LP cylinder connection
3. Inspect the connections and look for bubbles.
4. If no bubbles appear, the connection is safe.
Do not use a flame
to test for leaks!.
5. If bubbles appear, then there is a leak. Loosen and re-tighten the
connection where bubbles are present.
9.
Lower LP cylinder cover onto cylinder base.
Lower the LP cylinder
cover onto the Cylinder Base.
10.
Disconnect LP cylinder when storing or transporting.
Turn off
heater and turn off valve on LP cylinder. Disconnect the Regulator
and remove LP cylinder.
NOTE: Turn off valve on gas cylinder when heater is not in
use.
pole support
fixing
chain
tighten
cylinder
1.
2.
3.
4.
6.
7.
5.
