MHSC 36LCFL, Инструкция по установке и эксплуатации

Страница: 4 / 24

4 79D0007
Lo-Rider Vent Free Fireboxes
GENERAL INSTALLATION INFORMATION
DO NOT ATTEMPT TO BURN SOLID WOOD FUELS,
VENTED GAS LOG SETS, OR ANY OTHER COM-
BUSTIBLE IN THIS UNVENTED FIREBOx. ALSO, DO
NOT INSTALL A VENT-FREE GAS LOG SET IN THIS
FIREBOx IF THE MINIMUM CLEARANCE AND HEIGHT
REqUIREMENTS OF THE LOG SET ARE TOO LARGE
FOR THE FIREBOx.
The 36STFL, 36PFL, 36RCFL, and 36LCFL Series are
vent-free fireboxes. They feature a self-contained heat-
circulating system. These units also feature a -in-1 flex-
ible-face system (except for corner unit) that converts the
circulating system into a radiant system in seconds.
This installation manual will enable you to obtain a safe,
efficient, and dependable installation of your vent-free
fireplace system.
Do not alter or modify the firebox or its components under
any circumstances. Any modification or alteration of the
firebox system, including but not limited to the firebox and
accessories, may void the warranty, listings and approvals
of this system and could result in an unsafe and potentially
dangerous installation.
BEFORE YOU START:
CHECk YOUR PACkING LIST TO VERIFY THAT ALL
LISTED PARTS HAVE BEEN RECEIVED.
ALSO INSPECT THE CONTENTS FOR SHIPPING
DAMAGE AND IMMEDIATELY INFORM YOUR DEALER
IF ANY DAMAGE IS FOUND.
You should have the following:
1. Vent-Free Gas Firebox
. One (1) - 36" Canopy (36RCFL/36LCFL)
One (1) - 0" Canopy (36RCFL/36LCFL)
Two () - 36" Canopy (36STFL/36PFL)
3. Installation and Operating Instructions
4. Four (4) masonary screws
ITEMS REqUIRED FOR INSTALLATION
TOOLS and BUILDING SUPPLIES:
•
Phillips screwdriver
•
Square
•
Framing materials
•
Hammer
•
Saw and / or sabersaw
•
Tee joint
•
Level
•
Pipe wrench
•
Measuring tape
•
Pliers
•
Electric drill and bits
•
Fireplace surround materials (noncombustible)
•
Caulking material
(noncombustible)
•
Piping complying with local codes
•
Wall finishing materials
•
Pipe sealant approved for use with propane/L.P.G.
(resistant to sulfur compounds)
Refer to the installation instructions provided with the log
sets for items required for log set installation.
In planning the installation for the appliance it is necessary
to determine where the unit is to be installed and whether
optional accessories are desired. Gas supply piping should
also be planned. The following steps represent the normal
sequence of installation. Each installation is unique, how-
ever, and might require a different sequence.
1. Position firebox prior to framing or into prepared fram-
ing.
. Field wire main power supply to circulating models
with fan kit. (Electrical connections should only be
performed by an experienced, licensed/certified trades-
man).
3. Plumb gas line. (Gas connections should only be per-
formed by an experienced, licensed/certified trades-
man).
4. Install vent-free gas log heater per the instructions
provided with the vent-free gas log heater.
5. Complete finish wall material and surround to your
individual taste.
NOTICE
Illustrations shown in this manual reflect
“typical” installations with nominal
dimensions and are for design and framing
reference only. Actual installations may
vary due to individual design preferences.
However, always maintain minimum
clearances to combustible materials and
do not violate any specific installation
requirements.