4
Remove the battery door by gently pressing down on the battery cover
flange, then tip the door out and away from the unit. The O2D2 unit uses
3 standard quality AA DURACELL ULTRA alkaline batteries, or equivalent.
Insert the batteries as shown (they will be a tight fit), then replace the door
by setting the bottom of the door in place and tipping the top in until it
snaps in place. Take extra care when removing and replacing the batteries
to not damage the batteries and/or connectors.
INSERTING OR REMOVING THE TUBING
To INSERT the tubing
, push tubing in until resistance
is felt, then push in a little harder, about another 1/8 inch.
Then give it a gentle tug to make sure it has seated properly.
To REMOVE the tubing
, push tubing in slightly,
then push in the connector collar while you pull gently
on the tubing to remove it.
WHEN REMOVING TUBING;
DO NOT
PULL
ON THE TUBING WITHOUT PUSHING IN THE
COLLAR; IT WILL DAMAGE THE CONNECTOR.
When not being used,
the O2D2 unit, oxygen tubes, cannulas, etc., should be disconnected from the oxygen supply and
stored in a secure manner to ensure that dirt and debris do not become lodged in the inlet and outlet tubes. The supplied
tote bags or a zip-top plastic bag is a good storage container.
If the unit is not to be used for 30 days or more,
remove the batteries. When using the unit for the first time after storage, replace with new batteries
to ensure proper operation. A set of fresh spare batteries should be part of your pre-flight inventory.
Regardless of use replace batteries annually.
DO NOT STORE THE EDS UNIT WHILE THE INLET IS UNDER PRESSURE.
Remove all sources of oxygen pressure and
secure the unit to ensure it will not become damaged. If the un-pressurized supply line is left hooked to the system, make sure
that it is first purged with clean dry air or oxygen before the EDS unit is used.
If the lines are disconnected, the lines
must be covered so that debris, dust or dirt can’t get in.
MOUNTING THE MH EDS O2D2-2G
You may mount the O2D2 unit to a suitable place using the supplied piece
of 3M DUAL LOCK tape. First, cut the piece of DUAL LOCK tape in half,
lengthwise, creating two long rectangles. Peel the protective backing off
one of the rectangles to expose the adhesive and apply it to the back of
the unit above the thumb indent for the battery door. DO NOT COVER ANY
PART OF THE BATTERY DOOR. When a suitable place to mount the unit
has been found, peel off the protective adhesive backing and press the
adhesive side to the chosen mounting area.
INSERTING OR REMOVING THE BATTERIES
STORING THE MH EDS O2D2-2G
1.
Push
in the connecting collar
2.
Pull
the tube
straight back while
pushing
in the
connecting collar.
D-rings
Battery
Door
3M Tape
Before
Dual-Lock
Apply
Dual-Lock
Battery
Door
D-rings
4
A.
Push
in the tube
REMOVING
INSERTING
You may also mount the O2D2 by feeding 3/4”- wide straps
(not included) through the D-rings molded into the unit.
+
+
+
-
-
-
NOTE:
Batteries should be replaced annually or when voltage is low.
LITHIUM BATTERIES ARE NOT RECOMMENDED as the Low
Battery Voltage Indicator WILL NOT function correctly
