4
+ +
-
- -
+
Remove the battery door by pressing down gently on the battery cover
flange then tip the door out and away from the unit. The EDS-O2D2 unit
uses 3 standard quality AA DURACELL ULTRA alkaline batteries. Insert the
batteries as shown (they will be a tight fit), then replace the door by set-
ting the bottom of the door in place and tipping the top in until it snaps in
place. Take care when removing and replacing the batteries to not damage
the batteries and/or connectors.
REMOVING THE TUBING
To Remove the tubing, push in slightly on the tubing, then
push in the connector collar while you pull gently on the
tubing to remove it.
DO NOT pull on the tubing without pushing in
the collar; it will damage the connector.
When not being used, the MH EDS-O2D2 unit, oxygen tubes, cannulas, etc., should be disconnected from the oxygen supply
and stored in a secure manner to ensure that dirt and debris do not become lodged in the inlet and outlet tubes. The supplied
tote bags or a zip-top plastic bag is a good storage container.
If the unit is not going to be used for 30 days or more,
remove the batteries. When using the unit for the first time after storage, check the batteries to ensure proper
operation. A set of fresh spare batteries should be part of your pre-flight inventory.
DO NOT store the EDS unit while the inlet is under pressure.
Remove all sources of oxygen pressure and secure
the unit to ensure it will not become damaged. If the lines are disconnected they must be covered so that debris, dust or dirt
can’t get in. If the supply line is left hooked to the system, make sure that it is first purged with clean dry air or oxygen before
the EDS unit is connected.
If the lines are disconnected they must be covered so that debris, dust or dirt
can’t get in.
MOUNTING THE MH EDS-O2D2
You may mount the MH EDS-O2D2 unit to a suitable place using the sup-
plied piece of 3M DUAL LOCK tape. First, cut the piece of DUAL LOCK
tape in half, lengthwise, creating two long rectangles. Peel the protective
backing off one of the rectangles to expose the adhesive and apply it
to the back of the unit above the thumb indent for the battery door. DO
NOT COVER ANY PART OF THE BATTERY DOOR. When a suitable place to
mount the unit has been found, peel off the protective adhesive backing
and press the adhesive side to the chosen mounting area.
You may also mount the MH EDS-O2D2 by feeding 3/4”- wide straps
(not included) through the D-rings molded into the unit.
INSERTING OR REMOVING THE BATTERIES
STORING THE MH EDS-O2D2
1. Push in the collar
2. Pull the tube
straight back
while pushing
in the collar.
D-rings
Battery
Door
3M Tape
Before
Dual-Lock
Apply
Dual-Lock
Battery
Door
D-rings
4